Rohde & Schwarz FSW Series - 11.4.7.1 Configuring the Triggering Conditions

Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
245User Manual 1173.9240.02 ─ 17
11.4.7.1 Configuring the Triggering Conditions
TRIGger[:SEQuence]:BBPower:HOLDoff..........................................................................245
TRIGger[:SEQuence]:DTIMe...........................................................................................245
TRIGger[:SEQuence]:HOLDoff[:TIME]..............................................................................246
TRIGger[:SEQuence]:IFPower:HOLDoff...........................................................................246
TRIGger[:SEQuence]:IFPower:HYSTeresis...................................................................... 246
TRIGger[:SEQuence]:LEVel:BBPower..............................................................................247
TRIGger[:SEQuence]:LEVel[:EXTernal<port>].................................................................. 247
TRIGger[:SEQuence]:LEVel:IFPower...............................................................................247
TRIGger[:SEQuence]:LEVel:IQPower.............................................................................. 248
TRIGger[:SEQuence]:LEVel:RFPower..............................................................................248
TRIGger[:SEQuence]:LEVel:AM:RELative........................................................................ 248
TRIGger[:SEQuence]:LEVel:AM[:ABSolute]......................................................................249
TRIGger[:SEQuence]:LEVel:FM...................................................................................... 249
TRIGger[:SEQuence]:LEVel:PM...................................................................................... 249
TRIGger[:SEQuence]:SLOPe.......................................................................................... 250
TRIGger[:SEQuence]:SOURce........................................................................................250
TRIGger[:SEQuence]:TIME:RINTerval............................................................................. 252
TRIGger[:SEQuence]:BBPower:HOLDoff <Period>
This command defines the holding time before the baseband power trigger event.
The command requires the Digital Baseband Interface (R&S FSW-B17) or the Ana-
log Baseband Interface (R&S FSW-B71).
Note that this command is maintained for compatibility reasons only. Use the
TRIGger[:SEQuence]:IFPower:HOLDoff on page 246 command for new remote
control programs.
Parameters:
<Period> Range: 150 ns to 1000 s
*RST: 150 ns
Example:
TRIG:SOUR BBP
Sets the baseband power trigger source.
TRIG:BBP:HOLD 200 ns
Sets the holding time to 200 ns.
TRIGger[:SEQuence]:DTIMe <DropoutTime>
Defines the time the input signal must stay below the trigger level before a trigger is
detected again.
For input from the Analog Baseband Interface (R&S FSW-B71) using the baseband
power trigger (BBP), the default drop out time is set to 100 ns to avoid unintentional
trigger events (as no hysteresis can be configured in this case).
Configuring the Measurement