Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
326User Manual 1173.9240.02 ─ 17
Manual operation: See "Shift y" on page 153
CALCulate:LIMit<k>:LOWer:SPACing <InterpolType>
This command selects linear or logarithmic interpolation for the calculation of a lower
limit line from one horizontal point to the next.
Parameters:
<InterpolType> LINear | LOGarithmic
*RST: LIN
Manual operation: See "X-Axis" on page 152
See "Y-Axis" on page 152
CALCulate:
LIMit<k>:LOWer:STATe <State>
This command turns a lower limit line on and off.
Before you can use the command, you have to select a limit line with CALCulate:
LIMit<k>:NAME on page 326.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: SCPI confirmed
Manual operation: See "Visibility" on page 149
CALCulate:LIMit<k>:LOWer:THReshold <Threshold>
This command defines a threshold for relative limit lines.
The R&S FSW uses the threshold for the limit check, if the limit line violates the thresh-
old.
Parameters:
<Threshold> Numeric value.
The unit depends on CALCulate:LIMit<k>:UNIT
on page 327.
*RST: -200 dBm
Manual operation: See "Threshold" on page 151
CALCulate:LIMit<k>:NAME <Name>
This command selects a limit line that already exists or defines a name for a new limit
line.
Parameters:
<Name> String containing the limit line name.
*RST: REM1 to REM8 for lines 1 to 8
Analyzing Results
To Next Page
Loading...
