R&S NRP Remote Control - Fundamentals
1144.1400.12 5.19 E-3
SensorÆTriggerÆSource
TRIG[1..4]:SOUR
TRIG[1..4]:SLOP
SensorÆTriggerÆLevel
TRIG[1..4]:LEV
SensorÆTriggerÆAdvanced...ÆHoldoff
TRIG[1..4]:HOLD
SensorÆTriggerÆAdvanced...Æ Hyseresis
TRIG[1..4]:HYST
SensorÆTriggerÆAdvanced...ÆSingle There is no remote control command. The functionality can
only be achieved with an appropriate trigger system
configuration (e.g.
INIT:CONT ON;TRIG:SOUR
BUS
and triggering with *TRG).
WindowsÆWindow 1234
DISP:SEL
WindowsÆOpen/Close
DISP[1..4][:STAT]
WindowsÆExpand/Restore
DISP:SIZE
WindowsÆDig/D&A/Graph
DISP[1..4]:FORM
WindowsÆResolution
DISP[1..4]:RES
SENS[1..4]:AVER:COUN:AUTO:RES
WindowsÆTimeslot #
WindowsÆT'slot
DISP[1..4]:TSLot
WindowsÆAnalog Meter...ÆAuto Once
DISP[1..4]:MET:AUTO ONCE
DISP[1..4]:ANAL:AUTO ONCE
WindowsÆAnalog Meter...ÆLeft
DISP[1..4]:MET:LOW
DISP[1..4]:ANAL:LOW
WindowsÆAnalog Meter... ÆRight
DISP[1..4]:MET:UPP
DISP[1..4]:ANAL:UPP
Menu item in manual control SCPI command in short form
MeasurementÆWindow 1234
DISP[1..4]:SEL
MeasurementÆFunction...ÆPrimary Channel
MeasurementÆFunction...ÆSecondary Channel
MeasurementÆFunction...ÆFunction
CALC[1..8]:MATH:EXPR
MeasurementÆFunction...ÆUnit
UNIT:POW and UNIT:POW:RAT
MeasurementÆFunction...ÆAuxiliary Value
= Max
= Min
= Max - Min
DISP[1..8]:AVAL
CALC[1..8]:MAX:DATA?
CALC[1..8]:MIN:DATA?
CALC[1..8]:PTP:DATA?
MeasurementÆW / dBm / dBµV
UNIT:POW
MeasurementÆdB / ∆% / 1
UNIT:POW:RAT
MeasurementÆRel On / Off
CALC[1..8]:REL:STAT and
To Next Page
Loading...
