Rohde & Schwarz R&S NRP - Page 170

Remote Control - Fundamentals R&S NRP
1144.1400.12 5.20 E-3
MeasurementÆRel Reset
CALC[1..8]:REL:AUTO ONCE
MeasurementÆRef. Val...ÆRef. Value
CALC[1..8]:REL
MeasurementÆRef. Val...ÆRef. ValueÆReset (Result Æ Ref)
CALC[1..8]:REL:AUTO ONCE
MeasurementÆLimits...ÆWarning Sound
CALC[1..8]:LIM:BEEP
MeasurementÆLimits...ÆUpper Limit On
CALC[1..8]:LIM:UPP:STAT
MeasurementÆLimits...ÆUpper Limit
CALC[1..8]:LIM:UPP[:DATA]
MeasurementÆLimits...ÆLower Limit On
CALC[1..8]:LIM:LOW:STAT
MeasurementÆLimits...ÆLower Limit
CALC[1..8]:LIM:LOW[:DATA]
MeasurementÆMax Hold Reset
CALC[1..8]:EXTR:RES
FileÆ Preset
SYST:PRES or *RST
FileÆSetup Recall...ÆRecall
*RCL
FileÆSetup Save...ÆSave
*SAV
FileÆSetup Save...ÆEdit Name
MEM:STAT:DEF
FileÆStandard Recall...ÆPreserve Window Settings
SYST:STAN:PWS
FileÆStandard Recall...ÆTrigger Source
SYST:STAN:TRIG:SOUR
FileÆStandard Recall...ÆRecall
SYST:STAN:PRES
FileÆSensor Info...
SYSTem:SENS[1..4]:INFO?
FileÆSystem Info...
SYSTem:INFO?
FileÆWindow Name
DISP:NAME
SystemÆRemote... ÆGPIBÆGPIB Address
SYST:COMM:GPIB:ADDR
SystemÆI/O... ÆOut 1 1234
OUTP:REC1:FEED or OUTP:TTL:FEED
SystemÆI/O... ÆOut 1ÆAnalog
OUTP:REC1:STAT ON
SystemÆI/O... ÆOut 1ÆPass/Fail
OUTP:TTL:STAT ON
SystemÆI/O... ÆOut 1ÆOff
OUTP:REC1:STAT ON
OUTP:TTL:STAT ON
SystemÆI/O... ÆOut 1Æ0 V Equivalent (if Analog is selected)
OUTP:REC1:LIM:LOW...
SystemÆI/O... ÆOut 1Æ3 V Equivalent (if Analog is selected)
OUTP:REC1:LIM:UPP...
SystemÆI/O... ÆOut 1ÆFail (if Pass/Fail is selected)
OUTP:TTL:FAIL HIGH and
OUTP:TTL:HVOLT