Rohde & Schwarz R&S NRP - Page 171

R&S NRP Remote Control - Fundamentals
1144.1400.12 5.21 E-3
SystemÆI/O... ÆOut 1ÆPass (if Pass/Fail is selected)
OUTP:TTL:FAIL HIGH and
OUTP:TTL:LVOLT
SystemÆI/O... ÆI/O 2 1234
OUTP:REC2:FEED
SystemÆI/O... ÆI/O 2ÆAnalog Out
OUTP:REC2:STAT ON
SystemÆI/O... ÆI/O 2ÆTrigger In
OUTP:REC2:STAT OFF
SystemÆI/O... ÆI/O 2Æ0 V Equivalent (if Analog Out is
selected)
OUTP:REC2:LIM:LOW...
SystemÆI/O... ÆI/O 2Æ3 V Equivalent (if Analog Out is
selected)
OUTP:REC2:LIM:UPP...
SystemÆErrorlist
SYSTem:ERRor?
DISP:ERR:STAT
Menu item in manual control SCPI command in short form
SystemÆTest... ÆSensor ABCD / Init. Test
SYST:SENS[1..4]:TEST?
*TST?
SystemÆPower Ref
OUTP:ROSC
SystemÆDisplay Update
DISP:UPD
SystemÆMisc...ÆBeeperÆKey
SYST:BEEP:NOT:KEY
SystemÆMisc...ÆBeeperÆOverload
SYST:BEEP:NOT:OVER
( Æ )
DISP:CONT
(DEL/1TRIG)
If the "Single" check box was enabled in the Scope mode,
pressing (DEL/1TRIG) sends a
*TRG to the sensor.
({PRE}SET)
Opens the File menu
(FREQ)
SENS[1..4]:FREQ
(ZERO/CAL)
CAL:ZERO:AUTO