Rohde & Schwarz R&S NRP - Page 207

Remote Control - Commands R&S NRP
1144.1400.12 6.32 E-3
DISPlay:PIXMap? <block_data>
Supplies the display content as binary block data. The content is sent line by line with one bit
corresponding exactly to one pixel.
Example:
DISP:PIXM? returns: #49600xxxxxxx...x, with x in binary format comprising the display contents.
DISPlay:UPDate[?] NORMal | SLOW | FREeze
Adjust the update frequency of the measured values in the display. In case of discontinuities in the
voltage progress at the analog outputs display updates may be suspended with DISP:UPD FREeze.
The display won't consume CPU time in this state.
*RST-Value: NORMal
DISPlay[:WINDow][1..4]:AVALue[?] MINimum | MAXimum |
PTPeak | OFF
Determines which additional information about the measured values is shown in the display.
MINimum
MAXimum
Minimum/Maximum of all measured values since the last CALC:EXTR:RES or Power
On, respectively.
PTPeak
Differenz (linear units) or logarithmic ratio (logarithmic units) of maximum and minimum
of all measured values since the last CALC:EXTR:RES or Power On, respectively.
OFF
No additional information is displayed.
*RST-Wert: OFF
DISPlay[:WINDow][1..4]:FORMat[?] DIGital | ANALog | GRAPhical
Selects the display mode for measured data.
DIGital
Measured values are displayed in numeric format.
ANALog
Measured values are indicated by a marker on a scale. The values at the upper and
lower scale end as well as the type of scaling (linear or logarithmic) are set with the
following :METer commands.
GRAPhical
Measured values are plotted over time. This kind of presentation is possible only if the
Primary Channel is operated in Scope mode.
*RST value: DIGital