Rohde & Schwarz R&S NRP - Page 211

Remote Control - Commands R&S NRP
1144.1400.12 6.36 E-3
DISPlay[:WINDow][1..4]:TRACe:LOWer[?] <float_value>
Sets the lower limit for the power axis in the Scope mode. The value range depends on the unit.
Unit of measured value
W DBM DBUV
Value range
-999.999E3
..
999.999E3
-120
..
90
-13.010
..
136.990
Default unit: DBM
Unit: DBM | W | DBUV
Value range: see above
*RST value: -120 DBM
DISPlay[:WINDow][1..4]:TRACe:UPPer[?] <float_value>
Sets the upper limit for the power axis in the Scope mode. The value range depends on the unit.
Unit of measured value
W DBM DBUV
Value range
-999.999E3
..
999.999E3
-120
..
90
-13.010
..
136.990
Default unit: DBM
Unit: DBM | W | DBUV
Value range: see above
*RST value: 30 DBM
DISPlay[:WINDow][1..4]:TSLot[?] <int_value>
Sets the displayed timeslot, if the primary or secondary channel is operated in the Timeslot mode.
Value range: depends on sensor
*RST value: 1
DISPlay:WINDow:SELect[?] 1 | 2 | 3 | 4
Selects a window.
*RST value: 1