Rohde & Schwarz R&S NRP - Page 220

R&S NRP Remote Control - Commands
1144.1400.12 6.45 E-3
OUTPut:RECorder[1..2]:LIMit:LOWer[?] <float_value>
Power
Voltage
3.3 V
0.0 V
3.0 V
OUTP:REC:LIM:LOW OUTP:REC:LIM:UPP
Figure 6-5: Characteristic of analog outputs
Specifies the lower power limit of the characteristic for one of the two analog outputs (ÆFigure 6-5).
The unit corresponds to the output unit of the measured value.
The value range also depends on which output unit the measured value in the window currently has:
Unit of
measured
value
W DBM DBUV DPCT DB O
Value range
-9.99999E5
..
9.99999E5
-120
..
90
-13.0103
..
196.897
-100
..
999.99
-200
..
200
-1E20
..
1E20
Unit: Æ Table 6-3 on page 6.27.
*RST value: -20 DBM or 0 DB
Note: The characteristic is linear in the selected unit of the measured value.
OUTPut:RECorder[1..2]:LIMit:LOWer:POWer[?] <float_value>
Specifies the lower power limit of the characteristic for one of the two analog outputs if the associated
calculate block returns a power (unit DBM, W or DBUV) as measured value
(ÆFigure 6-5).
Value range: -120 DBM to 90 DBM
Unit: DBM | W | DBUV
Default unit: DBM
*RST value: -20 DBM