Rohde & Schwarz R&S NRP - Page 258

R&S NRP Remote Control - Commands
1144.1400.12 6.83 E-3
Operation Trigger Status Register
The CONDition register contains information as to whether a sensor is currently in the
WAIT_FOR_TRG state, i.e. expecting a trigger event and, depending on the configuration of the
transition register, the EVENt register indicates whether the WAIT_FOR_TRG state was entered or quit
by a sensor since the last readout of the register.
The Operation Trigger Status Register can be read by the following commands:
STATus:OPERation:TRIGger[:SUMMary]:CONDition?
STATus:OPERation:TRIGger[:SUMMary][:EVENt]? .
Table 6-23: Meaning of bits used in the Operation Status Register
Bit
No.
Meaning
0
Not used
1 Sensor A waiting for trigger
Sensor A is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change it to the MEASURING
state.
2 Sensor B waiting for trigger
Sensor B is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change it to the MEASURING
state.
3 Sensor C waiting for trigger
Sensor C is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change it to the MEASURING
state.
4 Sensor D waiting for trigger
Sensor D is in the WAIT_FOR_TRG state and is waiting for a trigger event that will change it to the MEASURING
state.
5 to
14
Not used
15
Bit 15 will never be used.