Remote Control - Commands R&S NRP
1144.1400.12 6.82 E-3
Operation Measuring Status Register
The CONDition register contains information as to whether a measurement is being performed by a
sensor and, depending on the configuration of the transition register, the EVENt register indicates
whether a measurement was started or completed since the last readout of this register.
The Operation Measuring Status Register can be read by the following commands:
STATus:OPERation:MEASuring[:SUMMary]:CONDition?
STATus:OPERation:MEASuring[:SUMMary][:EVENt]?.
Table 6-22: Meaning of bits used in the Operation Measuring Status Register
Bit
No.
Meaning
0
Not used
1 Sensor A measuring
Sensor A is performing a measurement.
2 Sensor B measuring
Sensor B is performing a measurement.
3 Sensor C measuring
Sensor C is performing a measurement.
4 Sensor D measuring
Sensor D is performing a measurement.
5 to14
Not used
15
Bit 15 will never be used.
To Next Page
Loading...
