Rohde & Schwarz R&S NRP - Page 256

R&S NRP Remote Control - Commands
1144.1400.12 6.81 E-3
Operation Calibrating Status Register
The CONDition register contains information as to whether a sensor is currently being calibrated and,
depending on the configuration of the transition register, the EVENt register indicates whether a
calibration was started or completed since the last readout of this register.
The Operation Calibration Status Register can be read by the following commands:
STATus:OPERation:CALibrating[:SUMMary]:CONDition?
STATus:OPERation:CALibrating[:SUMMary][:EVENt]? .
Table 6-21: Meaning of bits used in the Operation Calibrating Status Register
Bit
No.
Meaning
0
Not used
1 Sensor A is being calibrated
2 Sensor B is being calibrated
3 Sensor C is being calibrated
4 Sensor D is being calibrated
5 to
14
Not used
15
Bit 15 will never be used.