Rohde & Schwarz R&S NRP - Page 269

Remote Control - Commands R&S NRP
1144.1400.12 6.94 E-3
SYSTem:BEEPer:NOTify:KEY[?] ON | OFF
Enables (ON) or disables (OFF) acoustic key clicks, respectively.
*RST-Wert: OFF
SYSTem:BEEPer:STOP
Stops the output of an audible signal.
SYSTem:BEEPer:TIME <NRf>
Sets the length in milliseconds of the audible signal output with SYS:BEEP.
Value range:
1..60
Unit: S
*RST value: This setting is not changed by *RST.
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess <NR1>
Sets the address with which the R&S NRP can be addressed via the IEC/IEEE bus. The address is
factory-set to 20 and is not changed by a reset.
Value range: 0..30
*RST value: This setting is not changed by *RST.
SYSTem:DATE[?] <year>,<month>,<day>
Parameter Value range
<year>
2000 ... 2100
<month>
1 (January) ... 12 (December)
<day>
1 ... 31
Sets the date. Since the R&S NRP has no battery-backed clock, the date has to be reset if the clock
was not set after the last power-on of the R&S NRP.
*RST value: This setting is not changed by *RST.