Rohde & Schwarz R&S VENICE S800/824-G3 - Page 111

Administration
111
User Manual | 2906.2506.02 - 01
SNMP System Monitoring
R&S VENICE S
EmbeddedAudio2 Channel,
Card
Check if all
embedded audio
channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio2
EmbeddedAudio3 Channel,
Card
Check if all
embedded audio
channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio3
EmbeddedAudio4 Channel,
Card
Check if all
embedded audio
channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio4
AesAudio1 Channel,
Card
Status of the first two
AES audio channels:
unknown, detected,
notDetected
Check if all AES
audio channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio1
AesAudio2 Channel,
Card
Status of the second
two AES audio chan-
nels: unknown,
detected, notDetected
Check if all AES
audio channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio2
AesAudio3 Channel,
Card
Status of the second
two AES audio chan-
nels: unknown,
detected, notDetected
Check if all AES
audio channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio3
AesAudio4 Channel,
Card
Status of the second
two AES audio chan-
nels: unknown,
detected, notDetected
Check if all AES
audio channels are
connected, e.g.
received over SDI.
rsPriosBcV1-
Card[Card]Channel[C
hannel]EmbeddedAu-
dio4
rsSt2110V1MIB
(ST2110 video over IP specific information)
VideoSenderActive
Stream,
Channel,
(Card included
in Channel idx)
Status of the sender:
active, inactive
This is always active
as the data point is
not available if the IP
daemon is not
running.
rsSt2110V1Sender-
VideoCh[Channel]Id[
Stream]Active
VideoSenderRtp-
PktCnt
Stream,
Channel,
(Card included
in Channel idx)
Number of RTP
Packets send
An increasing count
signals that packets
have been sent.
rsSt2110V1Sender-
VideoCh[Channel]Id[
Stream]RtpPktCnt
AudioSenderActive
Stream,
Channel,
(Card included
in Channel idx)
Status of the sender:
active, inactive
This is always active
as the data point is
not available if the IP
daemon is not
running
rsSt2110V1Sender-
AudioCh[Channel]Id[
Stream]Active
Data Point Dimension Description Use Case SNMP Name