Product Description
43
User Manual | 2906.2506.02 - 01
The Rear of the System
R&S VENICE S
Out- or Input of Primary/Secondary Control Signals
RJ45 connector
During a standard operation the pin-outs of the RJ45 connector are adjusted
to secondary control mode. To use the full functionality of this connector you
have to use the supplied adapter cable. For more information about the
cable see chapter “Adapter Cable” on page 57. For the pin assignment see
chapter “RJ45 Connector” on page 56.
With software version 4 in normal operation R&S VENICE S is in secondary
control mode. With software version 3.5 it is possible to change between
primary and secondary mode in the R&S
VENICE UI software.
Downconvert Video Output
HD-BNC connector
The downconvert video output can be used for HD monitoring while the
system is configured for UHD operation. The downconvert functionality is
only active with UHD or 4K rasters. If enabled the UHD material will be send
via the SDI outputs (1 channel operation) and the HD material via the down-
convert output. In principle the signal is suitable for broadcast operations
(e.g. Simulcast Playout). Please note the following restrictions.
Ingest signals (e.g. ingest of external satellite feeds), which are
asynchronously to the output can cause frame repetitions or drop
frames.
To Next Page
Loading...