Administration
125
User Manual | 2906.2506.02 - 01
Integration into an IP Network
R&S VENICE S
Configuring the PTP Sync Mode
The PTP sync mode can be configured either through the R&S®Device
Manager or via the R&S VENICE Web Service (VeniceWS)
Using the
R&S®Device
Manager
Perform the following steps:
1.
Open the R&S®Device Manager as described in "Configuring the IP
interfaces" (page 120) and select the corresponding video server.
2. Navigate to Video Settings> Sync Reference.
3. (Optional) To disconnect the channels, do the following:
Navigate to Automation control and check which service is started
on each channel. You may have to click through each of the parame-
ters sections (VDCP, FIMS or MOS) to locate the channel and the
running service.
For each running channel click the Disconnect button.
4. In the Sync Reference panel set CURRENT CHANNEL to 1.
The Sync Reference panel will be displayed only if all channels of the se-
lected R&S VENICE S are set to I
DLE UNKNOWN state, which requires them
to be disconnected from current service. If the panel is displayed in your case,
proceed directly with step 4, otherwise first perform step 3.
To Next Page
Loading...