Troubleshooting
Troubleshooting an Internal USB Key
R&S VENICE S
176
User Manual | 2906.2506.02 - 01
Troubleshooting an Internal USB Key
Perform the following steps:
1.
Enter System Setup and ensure that the USB key port is enabled on
the Integrated Devices screen.
2. Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3. Remove the system cover as described in "Removing the System Cover"
on page 154.
4. Locate the USB key and reseat it.
5. Install the system cover as described in "Installing the System Cover" on
page 154.
6. Turn on the system and attached peripherals, and check if the USB key
is functioning.
7. If the problem is not resolved, repeat step 2 and step 3.
8. Insert a known working USB key.
9. Install the system cover as described in "Installing the System Cover" on
page 154.
If the problem persists, contact your local vendor or Rohde & Schwarz
directly.
To Next Page
Loading...