Maintenance
Removing and Mounting the System Cover
R&S VENICE S
154
User Manual | 2906.2506.02 - 01
Removing and Mounting the System Cover
Removing the System Cover
Requirements: Follow the safety guidelines listed in chapter “Safety Instructions” on
page 152 and chapter “Safety and regulatory information” on page 7.
If installed, remove the front plate.
If applicable, remove the system from the rack.
Perform the following steps:
1. Rotate the latch release lock counter clockwise to the unlocked position.
2. Lift the latch toward the back of the system.
The system cover slides back and the tabs on the system cover disen-
gage from the slots on the chassis.
3. Hold the cover on both sides, and lift the cover away from the system.
Installing the System Cover
Requirements: Follow the safety guidelines listed in chapter “Safety Instructions” on
page 152 and chapter “Safety and regulatory information” on page 7.
Ensure that all internal cables are connected and placed out of the way
and no tools or extra parts are left inside the system.
The position of the latch may vary depending on the configuration
of your system.
To Next Page
Loading...