Administration
Integration into an IP Network
R&S VENICE S
128
User Manual | 2906.2506.02 - 01
Configuring the NMOS Node Settings
Configuration of NMOS node settings is available via the R&S®Device
Manager.
Perform the following steps:
1.
Open the R&S®Device Manager as described in "Configuring the IP
interfaces" (page 120) and select the corresponding video server.
2. Navigate to Video settings > Global NMOS settings.
3. Set the corresponding values for R&S VENICE S:
NMOS Stream Configuration
Instead of one SDI input port and one SDI output port for video, audio and
ANC I/O, the IP R&S VENICE provides NMOS resources for sending and
receiving IP streams over one channel. In contrast to SDI, specific NMOS
sender and receiver resources need to be configured separately for each
data type, such as audio, video and ANC. These recourses are prepared
externally as JSON files which are then imported using the Device Manager
interface.
The last three settings at the bottom are intended for unicast based registra-
tion servers.There is no need to specify those settings if a multicast based
registration server is used.
To Next Page
Loading...