Rohde & Schwarz R&S VENICE S800/824-G3 - The Rear of the System; Back Panel

Product Description
The Rear of the System
R&S VENICE S
40
User Manual | 2906.2506.02 - 01
The Rear of the System
Back Panel
Back panel
1
5
2
1
2
3
4
6
7
8
9
10
11
11
13
14
11
11
6
12
12
1 HD Sub-D
connector
N/A LTC In/Out
For more information see "LTC In/Out" on page 41 and for the pin
assignment "HD Sub-D Connector (LTC In/Out)" on page 55.
2 RJ45 connector,
serial RS-422 inter-
face (4)
N/A Out- or input of primary/secondary control signals
For more information see "Out- or Input of Primary/Secondary Control
Signals" on page 43 and for the pin assignment chapter “RJ45
Connector” on page 56.
3 2 x PCIe exansion
card (slot 3 and slot
6)
N/A Provides slots for two PCI Express expansion cards.
4 USB 2.0 port) Enables you to connect USB devices to the system. This port is USB
2.0-compliant.
5 2 x PCIe exansion
card (slot 7 and slot
8)
N/A Provides slots for two PCI Express expansion cards.
6 Power supply unit
(PSU) (2)
N/A AC 2400 W
For more information see chapter “Power Supply Unit” on page 42.
7 Video connector Enables you to connect a VGA display to the system. For the pin
assignment see chapter “Video Connector” on page 57.
8 USB port (2) Enables you to connect USB devices to the system. This port is USB
3.0-compliant.
9 iDRAC Enterprise
port
Dedicated management port.
10 System identifica-
tion button
The identification buttons on the front and back panels can be used to
locate a particular system within a rack. When one of these buttons is
pressed, the LCD panel on the front and the system status indicator
on the back flashes until one of the buttons is pressed again. Press to
toggle the system identification (ID) on or off.