Administration
Integration into an IP Network
R&S VENICE S
120
User Manual | 2906.2506.02 - 01
General Network Settings
For the initial configuration of the IP settings, a client PC is required that is
directly connected to the default 1G configuration network interface
"eno
8403" on the R&S VENICE S server (factory default: static IP 10.0.0.8).
The corresponding client PC's network port needs to be configured to an IP
address that is in the same network (e.g. 10.0.0.9).
Configuring
the IP inter-
faces
If the R&S VENICE S server already got a dedicated management network
IP configured on one of the two available 1G network interfaces ("eno
8303"
or "eno
8403"), just use that port for the network settings configuration.
Perform the following steps:
1.
Open the R&SĀ®Device Manager in your Chrome browser by using the
management network interface IP address.
2. Log in to the Device Manager web frontend:
username: administrator; password: [serial number of the device]
With version 1.0.0.0 to 1.5.1.0 use password admin.
Required Interfaces
Interface Card
[cardIndex]
SMPTE 2110
Port
[portIndex]
Model
rsip0s0
(Default 2022-7 main interface)
0 0 R&S VENICE
S4/S8
rsip0s1
(Default 2022-7 secondary inter-
face)
1
rsip0s2 2
rsip0s3 3
rsip1s0
(Default 2022-7 main interface)
1 0 R&S VENICE S8
only
rsip1s1
(Default 2022-7 secondary inter-
face)
1
rsip1s2 2
rsip1s3 3
To Next Page
Loading...