Maintenance
Replacing a Cooling Fan Assembly
R&S VENICE S
160
User Manual | 2906.2506.02 - 01
Replacing a Cooling Fan Assembly
Requirements: Follow the safety guidelines listed in chapter “Safety Instructions” on
page 152 and chapter “Safety and regulatory information” on page 7.
If applicable, remove the system from the rack.
Remove the system cover as described in chapter “Removing the
System Cover” on page 154.
Perform the following steps:
1. Unlock the cooling fan assembly from the chassis by lifting the release
levers.
2. Lift the cooling fan assembly out of the chassis.
3. Align the slots on the cooling fan assembly with the guide pins on the
chassis.
4. Slide the new cooling fan assembly into the chassis.
To Next Page
Loading...