Maintenance
159
User Manual | 2906.2506.02 - 01
Replacing a Hot Swappable Hard Drive
R&S VENICE S
3.
Install a hard drive in the hard drive carrier.
4. Press the release button on the front of the hard drive carrier and open
the hard drive carrier handle.
5. Insert the hard drive carrier into the hard drive slot until the carrier
connects with the backplane.
6. Close the hard drive carrier handle to lock the hard drive in place.
7. Turn on the hard drive.
8. If removed, install the front plate.
Data Loss
When a replacement hot swappable hard drive is installed
and the system is powered on, the hard drive automatically
begins to rebuild. Any data on the replacement hard drive is
immediately lost after the hard drive is installed.
Make absolutely sure that the replacement hard drive is
blank or contains data that you wish to have over-
written.
Combining SAS and SATA hard drives in the same RAID volume is
not supported.
To Next Page
Loading...