Rohde & Schwarz R&S VENICE S800/824-G3 - Replacing the Internal USB Memory Key

Maintenance
163
User Manual | 2906.2506.02 - 01
Replacing the Internal USB Memory Key
R&S VENICE S
Replacing the Internal USB Memory Key
Requirements:  Follow the safety guidelines listed in chapter “Safety Instructions” on
page 152 and chapter “Safety and regulatory information” on page 7.
 If installed, remove the front plate.
 If applicable, remove the system from the rack.
 Remove the system cover as described in chapter “Removing the
System Cover” on page 154.
Perform the following steps:
1. Remove the USB memory key from the USB port.
2. Insert the replacement USB memory key into the USB port.
3. If applicable, install the system into the rack.
4. If removed, install the front plate.
5. While booting, press [F2] to enter System Setup and verify that the
system detects the USB memory key.
6. Install the system cover as described in chapter “Installing the System
Cover” on page 154.