Rohde & Schwarz R&S VENICE S800/824-G3 - Integration into an IP Network; Preconditions

Administration
119
User Manual | 2906.2506.02 - 01
Integration into an IP Network
R&S VENICE S
Integration into an IP Network
This section guides you through the process of transforming R&S VENICE S
with SDI support to also support professional video, audio and ancillary data
transmission over an IP network.
The following topics are covered
● Preconditions (page 119)
● General Network Settings (page 120)
● Installing the IP Software (page 123)
● Channel Configuration (page 123)
● Activating the SMPTE 2110 IP Interfaces (page 124)
● Configuring the PTP Sync Mode (page 125)
● Configuring the PTP Parameters (page 127)
● Configuring the NMOS Node Settings (page 128)
● NMOS Stream Configuration (page 128)
Preconditions
For the integration into an IP network, R&S VENICE S requires the installa-
tion of SFP modules which have to be ordered separately.
R&S VENICE S might be connected with up to three different networks:
● Management network for configuration and video server protocols
(VDCP, FIMS, MOS, VeniceWS, WSDD)
● Media over IP network (SMPTE 2110, NMOS)
● Optional: Storage network (e.g. SpycerNode)
Ordering Information
Article name Article order number Comments
VEN-B433 VOIP
SFP BUNDLE (4X)
2906.1574.02 R&S VENICE S4: 1x needed
R&S VENICE S8: 2x needed
We recommend to use static IP addresses on all required R&S VENICE S
network interfaces (no DHCP).