Installation and Configuration
Starting the System
R&S VENICE S
76
User Manual | 2906.2506.02 - 01
Starting the System
After a proper installation of the system you may start the R&S VENICE S
system at any time.
Perform the following steps:
• Press the power switch briefly to turn on the system.
The system will be started. It takes several minutes until the system is
fully operational.
For the initial setup the device must be integrated into a network. If the IP of
the device is already known a remote SSH terminal (e.g. Putty) can be used
to make the basic configuration. Alternatively a monitor and keyboard can be
temporarily connected on the front or on the rear of the system. Continue
with chapter “Configuring the System” on page 77.
To Next Page
Loading...