Product Description
Pin Assignment
R&S VENICE S
56
User Manual | 2906.2506.02 - 01
RJ45 Connector
The RJ45 connector enables you to use Primary/Secondary control. For
more information see chapter “Out- or Input of Primary/Secondary Control
Signals” on page 43.
RJ45 connector, serial RS-422 interface (4) (external view on device
[female])
RJ45 Secondary Mode (default) Primary Mode
Pin No. Signal Signal
1 GND GND
2 reserved reserved
3 RX (+) TX (+)
4 TX (-) RX (-)
5 TX (+) RX (+)
6 RX (-) TX (-)
7 not connected not connected
8 not connected not connected
If you want to manufacture a direct line VDCP cable please note the
secondary mode assignment above. Your VDCP cable should con-
nect the automation’s TX+/- pins with the RX+/- pins of the R&S
VENICE S and vice versa (+ to + and - to - and of course
GND/ground).
To Next Page
Loading...