Administration
99
User Manual | 2906.2506.02 - 01
Creating a Backup Image
R&S VENICE S
Creating a Backup Image
The following describes the steps to make a backup image of the system
disk and save it to the internal USB flash drive, see "Rescue Stick"
(page 54).
Perform the following steps:
1.
If appropriate, disconnect all externally connected storage devices from
the system.
2. Turn on the R&S VENICE S. At the indicated moment during start-up you
have to press [F11] to enter the boot menu.
The boot menu is displayed on the screen.
3. Select the internally installed USB flash drive as the boot device.
4. Press [Enter].
The system will boot from the internal USB flash drive.
You will see a window on the screen where you can select the Rohde
& Schwarz Rescue environment for loading.
5. Select RuS Rescue and press [Enter].
To complete the loading of the Rohde & Schwarz Rescue environ-
ment some user entries are required. For this follow the instructions
given on the screen.
The loading of the environment and the process itself will both try to
initialize hardware that may not be present on your system. Any er-
ror messages displayed during loading/initialization, e.g. Failed or
Warning, can be disregarded. The backup/recovery process
should work nonetheless.
To Next Page
Loading...