Maintenance
155
User Manual | 2906.2506.02 - 01
Removing and Mounting the System Cover
R&S VENICE S
Perform the following steps:
1.
Align the slots on the system cover with the tabs on the chassis.
2. Push the system cover latch down to move the system cover into the
closed position.
The system cover slides forward and the tabs on the system cover
engage with the slots on the chassis. The system cover latch locks
into place when the system cover engages with the slots on the
chassis.
3. Rotate the latch release lock clockwise to the locked position.
4. If applicable, install the system into the rack.
5. If removed, install the front plate.
6. Reconnect the peripherals and connect the system to the electrical
outlet.
7. Turn on the system, including any attached peripherals.
To Next Page
Loading...