Maintenance
157
User Manual | 2906.2506.02 - 01
Replacing a Power Supply Unit
R&S VENICE S
Perform the following steps:
1.
Disconnect the power wires from the power source and the connector
from the PSU you intend to remove.
2. Press the release latch and slide the PSU out of the chassis by using the
PSU handle.
3. Slide the new PSU into the chassis until the PSU is fully seated and the
release latch snaps into place.
4. If you have unlatched the cable management arm, re-latch it.
5. Connect the power cable to the PSU and plug the cable into a power
outlet.
6. Secure the cable with the strap.
7. If applicable, install the system into the rack.
8. If removed, install the front plate.
When installing, hot-swapping, or hot-adding a new PSU, wait for
15 seconds for the system to recognize the PSU and determine its
status. The PSU status indicator turns green to signify that the PSU
is functioning properly.
To Next Page
Loading...