Product Description
Features
R&S VENICE S
26
User Manual | 2906.2506.02 - 01
With one of the following values in the "AFD Data Mode" in the R&S
®
Device
Manager or via the R&S VENICE web service it can be determined, if the
existing AFD data file should be used or if this data should be overwritten:
The „AFD Reset Mode“ can used to determine whether the AFD overwrite
should be valid only for this clip or until further notice.
Supported Conversion Using AFD
R&S VENICE S can be configured for SD, HD and UHD playout. So the
server supports many different clip-related aspect ratio conversions (ARC)
as shown in the following:
If transcoding one file format into another file format during ingest
as well as transcoding the AFD information could be lost with the
following format: MXF (OP Atom, Sony XDCam IMX, AS02, AS11,
IMF).
AFD data couldn‘t be lost with following formats: MXF (OP1a Ge-
neric, RDD09, Sony XDCam DV, XAVC) and MPEG-2.
Strip All AFD data is removed.
PassThrough The existing AFD data is passed through.
Generate The existing AFD data is passed through. If no AFD data is present, AFD data is
generated based on the current settings.
Replace The AFD data is always generated based on the current settings. Existing AFD
data is replaced.
AFD In Input (4:3) AFD Out Output (16:9)
0001 Reserved - Invalid
0010 Letterbox 16:9 image,
at the top of the coded frame
1000 Full frame 16:9 image,
the same as the coded frame
0011 Letterbox 14:9 image,
at the top of the coded frame
1011 Pillarbox 14:9 image,
horizontally centered in the coded
frame
0100 Letterbox image with an aspect ratio
greater than 16:9, vertically centered in
the coded frame
0100 Letterbox image with an aspect ratio
greater than 16:9, vertically
centered in the coded frame
0101 Reserved - Invalid
0110 Reserved - Invalid
0111 Reserved - Invalid
1000 Full frame 4:3 image,
the same as the coded frame
1001 Pillarbox 4:3 image,
horizontally centered in the coded
frame
To Next Page
Loading...