Safety and regulatory information
9
User Manual | 2906.2506.02 - 01
Safety instructions
R&S VENICE S
The system is to be operated only when mounted and mechanically secured
into a 19-inch wide rack.
Setting up the product
Always place the product on a stable, flat and level surface with the bottom
of the product facing down. If the product is designed for different positions,
secure the product so that it cannot fall over.
If the product has foldable feet, always fold the feet completely in or out to
ensure stability. The feet can collapse if they are not folded out completely or
if the product is moved without lifting it. The foldable feet are designed to
carry the weight of the product, but not an extra load.
If stacking is possible, keep in mind that a stack of products can fall over
and cause injury.
If you mount products in a rack, ensure that the rack has sufficient load
capacity and stability. Observe the specifications of the rack manufacturer.
Always install the products from the bottom shelf to the top shelf so that the
rack stands securely. Secure the product so that it cannot fall off the rack.
Unplug the system before you move it or if you think it has become damaged
in any way.
Connecting to power
The product is an overvoltage category II product. Connect the product to a
fixed installation used to supply energy-consuming equipment such as
household appliances and similar loads. Keep in mind that electrically
powered products have risks, such as electric shock, fire, personal injury or
even death.
Take the following measures for your safety:
● The enclosure must only be operated from a power supply input voltage
range of 100-240 VAC, frequency is 50 to 60 Hz.
● Before switching on the product, ensure that the voltage and frequency
indicated on the product match the available power source. If the power
adapter does not adjust automatically, set the correct value and check
the rating of the fuse.
● Only use the power cable delivered with the product. It complies with
country-specific safety requirements. Only insert the plug into an outlet
with protective conductor terminal.
● Only use intact cables and route them carefully so that they cannot be
damaged. Check the power cables regularly to ensure that they are
undamaged. Also ensure that nobody can trip over loose cables.
● If the product needs an external power supply, use the power supply that
is delivered with the product or that is recommended in the product docu-
mentation or a power supply that conforms to the country-specific regula-
tions.
● Only connect the product to a power source with a fuse protection of
maximum 20A.
To Next Page
Loading...