Rohde & Schwarz SR8000 Series - Setup > RS232 Menu Window

Chapter 5 Operation
5300.9677.71 - 5.32 - EN-4
– to a PC or laptop via the Ethernet interface on the front panel (cross cable),
– to a LAN/WAN via the Ethernet interface on the rear panel.
You can manually enter the parameters for the port on the front or rear panel to suit your
requirements.
2.5.4 Setup > RS232 Menu Window
You can enter the settings for RS232 interface X41 in the RS232 menu window.
Note RS232 functionality requires a special internal hardware option.
Selection Description
Front Ethernet
IP Address IP address
Subnet mask Subnet mask
Rear Ethernet Manual settings should only be made in the offline mode (context menu:
Edit Offline) and then activated with Submit Changes (context menu).
a)
a) If the transmitter is configured for use in 1+1 or n+1 standby systems, the IP address cannot be changed.
IP Address IP address
Subnet mask Subnet mask
Gateway Entry of a gateway address (assigned by the network administrator).