Chapter 5 Operation
5300.9677.71 - 5.11 - EN-4
Editing entries
In the editor, it is only possible to add new characters to existing characters. To insert char-
acters at a certain position, you must first delete any existing characters from right to left
and then enter new characters starting at the current cursor position.
The editor is closed by selecting Enter text or Discard; you then return to the menu win-
dow. If you select the Fix Editor command in the context menu, the editor will remain open
until you close it by pressing the Back key.
1) Entry line
2) Selectable characters
3) Command line
1. To enter characters, move to the required character using the cursor keys and then con-
firm with the OKkey.
The selected character appears in the entry line.
or
To delete characters in the entry line, select Del char using the cursor keys and then
confirm with the OKkey.
The characters in the entry line are deleted one by one from right to left.
2. To save changes (current entry in the entry line), select Enter text using the cursor keys
and then confirm with the OKkey.
This closes the editor, stores the changes, and displays them in the menu window.
or
To close the editor without saving the changes, select Discard using the cursor keys and
then confirm with the OKkey.
The editor closes and you return to the menu window. Your changes are not saved.
3. Press the HOMEkey to finish menu editing.
1.2.1.3 Context menu
The context menu contains function- and content-oriented commands which can be applied
to the currently displayed menu.
To Next Page
Loading...
