Chapter 2 Design and Function
5300.9677.72 - 2.21 - EN-4
2 Specifications
RF output power
Standalone instrument .......................... 100/250/500/1000/1300 W
Combination ......................................... 2500 W (2 x 1250 W)
Dimensions
Width .................................................... 420 mm (19“)
Depth .................................................... R&S SR8010: 510 mm (excl. handles) R&S
SR8025/SR8050: 590 mm (excl. handles) R&S
SR8100/SR8130: 590 mm (excl. handles) R&S
SR8250A: 590 mm (excl. handles)
Height ................................................... R&S SR8010: 2 HU R&S SR8025/SR8050/
SR8100/SR8130: 4 HU R&S SR8250A: 8 HU
(2 x 4 HU)
Weight (depends on transmitter type)
R&S SR8010 ......................................... < 10 kg
R&S SR8025/SR8050 ........................... < 25 kg
R&S SR8100 ......................................... < 26 kg
R&S SR8130 ......................................... < 31 kg
R&S SR8250A....................................... < 62 kg (2 x 31 kg)
Frequency range ........................................ 87.5 MHz to 108 MHz
RF connector
R&S SR8010 ......................................... N female
R&S SR8025/SR8050 ........................... 7/16“ female
R&S SR8100/SR8130 ........................... 7/16“ female
R&S SR8250A....................................... 7/16“ female
Voltage supply ............................................ 100 - 240 V/50 - 60 Hz 220 - 240 V/50 - 60 Hz
for R&S SR8100
Operation/remote-control interfaces
B/W display ¼ VGA
Built-in parallel remote-control interface (relay, optocoupler)
Web/SNMP interface (Ethernet/IP based)
Ethernet interface (front/rear)
Modulation interfaces
Audio Left/Right; MPX (analog signals)
Audio AES/EBU (digital signal)
2 external SCA inputs (additional analog signals)
1 internal SCA input
Pilot tone outputs (19 kHz) for RDS coder
Measurement points
To Next Page
Loading...
