Chapter 5 Operation
5300.9677.71 - 5.7 - EN-4
1.2 Local Operation
1. Press the LOCAL key on the transmitter.
The yellow LED to the left of the LOCAL key lights up. The display in the middle of the
System Overview window changes from: Remote <--> Local
2. Press the HOME key.
The following picture appears on the LCD display.
1) Forward power display (analog and digital)
2) Reflected power display (analog and digital)
3) General transmitter status display
4) Stylized display of exciters, amplifiers, and antenna circuit
The three boxes in the status display are allocated as follows:
W in the box on the left - a warning exists.
F in the box in the middle - a fault exists.
RF in the box on the right - the transmitter output power is OK.
Transmitter set to Local or Remote mode
The three boxes in the exciter diagram are allocated as follows:
When a warning exists, W is displayed in the box on the left.
When a fault exists, F is displayed in the box in the middle.
When control power is available, RF is displayed in the box on the right.
The three boxes in the amplifier diagram (output stage) are allocated as follows:
When a warning exists, W is displayed in the box on the left.
When a fault exists, F is displayed in the box in the middle.
When output power is available, RF is displayed in the box on the right.
To Next Page
Loading...
