Chapter 8 Service
5300.9677.72 - 8.6 - EN-4
3 Replacing Fan
Two fans for cooling the transmitter are located on the rear panel of the transmitter, where
they are easily accessible from outside.
3.1 Removing the Fan
3.1.1 R&S SR8010
1. Undo the cable clamp (Torx screwdriver, size 8) and cut through the cable tie.
Fig. 1 Undoing cable clamp
2. Press the catch (X31: at top; X32: at bottom) on the connector of the faulty fan and dis-
connect the connector.
To Next Page
Loading...
