Chapter 4 Putting into Operation
5300.9677.72 - 4.7 - EN-4
2.2.2 Entering Default Settings
This is how you enter the basic settings for the transmitter.
) Select Transmitter > Setup > Common.
The Common window opens.
You can enter the following settings in the Common window:
2.2.3 Configuring R&S SR8250A System
Note The following setting is only possible on an R&S SR8130 (component of the R&S SR8250A
system).
In order to operate an R&S SR8250A, the separate R&S VU813 amplifier must be logged
onto the software.
1. Select Transmitter > Setup > System.
The System window opens.
Selection Explanation
Date Current date
Time Local time
Display Timeout Time in minutes after which the display switches off (standby)
Display Brightness Used to adjust the display brightness (values 1 to 10)
Display Contrast Used to adjust the display contrast (values 1 - 10)
To Next Page
Loading...
