Chapter 5 Operation
5300.9677.71 - 5.6 - EN-4
Fig. 1 Operating buttons
Note After entering any settings that affects the configuration, please return the authorization lev-
el to its lowest possible setting. This will stop unauthorized personnel from entering settings
that could harm the operation of the transmitter.
Note In the event of a power failure the transmitter resets to the lowest authorization level.
User profile Description
Configuration Authorization to set basic transmitter parameters, e.g. Setup
Maintenance Authorization to perform maintenance tasks, e.g. software updates
Operation Authorization to make settings that directly affect transmitter operation
Query Read-only authorization
Guest
a)
a) The IDs Superuser and Guest are only available via the web browser.
Read-only authorization
Config-Engl Authorization to set basic transmitter parameters, e.g. setup; this ID also
changes the menu language to English (irrespective of the preset lan-
guage, e.g. Chinese)
Superuser
a)
Authorization to configure, create and delete user profiles and to display
and delete active sessions; no authorization for setting transmitter
parameters; see Query
ATTENTION!
Please note that when operating by remote control via the rear-panel Ethernet connection,
you can only make changes to menu items via the browser (e.g. Internet Explorer, Mozilla
Firefox, etc.) if the transmitter is set to Remote; if necessary press the LOCAL button on
the transmitter (the yellow LED should go out).
Please note that in the opposite case, i.e. "Local Operation", you can only make changes
to individual menu items via the transmitter keypad if the transmitter is set to LOCAL; if
necessary press the LOCAL button on the NETCCU® (the yellow LED should come on).
To Next Page
Loading...
