Chapter 5 Operation
5300.9677.71 - 5.13 - EN-4
Note Depending on their rights, logged-on users can monitor the transmitter in question or con-
trol all of its functions. There is no difference between PC control and remote control with
respect to this functionality.
The transmitter contains the components for operation by PC or remote control as standard:
Network port (10/100 MBit)
1.3.1 Installation and Configuration
Connecting a PC/client
1. Connect the transmitter to a local PC by means of an RJ-45 crossover cable attached
to the Ethernet socket on the front panel of the instrument.
Fig. 3 Ethernet link using a crossover cable connection
or
Connect the transmitter to your network with the aid of an RJ-45 1:1 cable attached to
the X6 Ethernet socket on the rear panel of the instrument.
Fig. 4 Link to a network using an RJ-45 1:1 cable connection
Entering IP address at transmitter
Before you can use your browser to log on to the transmitter, you first have to enter the
IP address manually via the front panel or choose automatic entry.
The parameters for connecting to the transmitter via the front panel are fixed settings and
cannot be changed.
1. Select the Setup > Ethernet menu at the front panel.
To Next Page
Loading...
