Rohde & Schwarz SR8000 Series - Checking the Output Stage Status Display; Clearing Event Memories

Chapter 4 Putting into Operation
5300.9677.72 - 4.24 - EN-4
7. Check the status of the warning and error indicators.
3.1.3 Checking the Output Stage Status Display
1. Select Transmitter > Output Stage > Status.
The Output Stage > Status window opens.
Note The available displays depend on whether the system has a separate amplifier (right-
hand menu window) or not (lefthand menu window).
2. Check the status of the warning and error indicators. If no warnings or errors are sig-
naled, the transmitter is ready to operate.
3.2 Clearing Event Memories
The transmitter has four event memories.
 Summary
 Status
 Warning
 Fault