Rohde & Schwarz SR8000 Series - Setting the Nominal Deviation, Configuring the Limiter

Chapter 4 Putting into Operation
5300.9677.72 - 4.13 - EN-4
2. Select the required settings.
The table below explains the adjustable parameters:
2.3.3 Setting the Nominal Deviation, Configuring the Limiter
1. Select Transmitter > Exciter > Deviation/Limiter.
The Deviation/Limiter window opens.
Setting item Description
Pilot tone Setting of the deviation produced by the pilot tone for stereo
Value range: 2 kHz through 10 kHz (default setting 7 kHz)
Active (Pilot tone) Switches the pilot tone on and off (active only in stereo mode; the pilot
tone is always off in mono mode)
Preemphasis Selection of the signal preemphasis: 50 µs (default setting) or 75 µs
Active (Preemphasis) For switching preemphasis on or off (with MPX mode still inactive)
Display Description
Actual Modulation Displays the current modulation format setting
(the modulation format is defined in the Input > Automatic Input menu
window)
Tip: The context menu (Menu key) contains the entry Mod. Select for
directly calling the Input > Automatic Input menu window. The Back
key takes you back to the original menu.