Rohde & Schwarz SR8000 Series - System and Operating Parameters Configuration; Parameter Set Menu Management

Chapter 4 Putting into Operation
5300.9677.72 - 4.6 - EN-4
2 Putting a Transmitter into Operation
Local operation of the transmitter includes all the main information calls for the system pa-
rameters and their setting, complete with intuitive graphical menus.
Remote operation via a web browser is possible only if a PC or notebook is connected to
the front or rear panel of the transmitter.
2.1 Preparing for Local Operation
To prepare for local control proceed as follows:
) Press the LOCAL key on the transmitter.
The corresponding yellow LED should come on.
2.2 Checking and Setting System and Operating Param-
eters
2.2.1 Changing the User Type
To configure the transmitter you must have configuration rights.
To log on, proceed as follows:
1. From the context menu, select the menu item Change User.
The Logon window opens, displaying the currently valid user type.
2. Log on as the user type Configuration by selecting one of the two available options
(select or type user). No password is necessary in the case of local operation via the
display.