Rohde & Schwarz SR8000 Series - Operation

Chapter 4 Putting into Operation
5300.9677.72 - 4.3 - EN-4
CONTENTS
1 General Information ......................................................................... 4
1.1 Preparations ....................................................................................................4
1.2 Requirements ..................................................................................................4
1.3 Operating the Transmitter .............................................................................5
2 Putting a Transmitter into Operation ............................................. 6
2.1 Preparing for Local Operation .......................................................................6
2.2 Checking and Setting System and Operating Parameters .........................6
2.2.1 Changing the User Type ..............................................................................6
2.2.2 Entering Default Settings ..............................................................................7
2.2.3 Configuring R&S SR8250A System .............................................................7
2.2.4 Configuring Transmitter Standby and Remote-Control Interface .................8
2.2.5 Configuring Rear Panel Ethernet Connection ..............................................9
2.3 Setting Modulation-Specific Parameters ....................................................10
2.3.1 Selecting the Modulation Mode ..................................................................10
2.3.2 Setting Pilot Tone and Preemphasis ..........................................................12
2.3.3 Setting the Nominal Deviation, Configuring the Limiter ..............................13
2.3.3.1 Deviation and MPX Limiters ............................................................................. 15
2.3.4 Setting the Audio Parameters ....................................................................16
2.3.4.1 Setting Input Impedances for Analog AUDIO ................................................... 16
2.3.4.2 Entering Settings for Digital Audio .................................................................... 17
2.3.4.3 Setting the Parameters for the AUX inputs (incl. RDS) .................................... 18
2.3.5 Setting the Transmission Frequency ..........................................................19
2.4 Entering Output Stage Settings ..................................................................19
2.4.1 Setting Output Power Thresholds ..............................................................19
2.4.2 Setting the Output Stage ............................................................................20
3 Completing Procedure for Putting Transmitter into Operation . 22
3.1 Checking the Status Displays .....................................................................22
3.1.1 Checking the Transmitter Status Display ...................................................22
3.1.2 Checking the Exciter Status Displays .........................................................22
3.1.3 Checking the Output Stage Status Display ................................................24
3.2 Clearing Event Memories .............................................................................24
4 R&S NetCCU800 Setup for 1+1/N+1 Systems with
R&S SR8000 ................................................................................... 26