Rohde & Schwarz SR8000 Series - Interface Description

Chapter 9 Appendix
5300.9677.72 - 9.3 - EN-4
CONTENTS
1 Interface Description ....................................................................... 4
1.1 Front-Panel Interfaces ....................................................................................4
1.1.1 ETHERNET (X50) - Control Interface for Local (RJ45): Connector, Female,
8-Pin .............................................................................................................4
1.1.2 TEST (X60) – Test Output: SMA Connector ................................................4
1.1.3 RF (X7) – RF Test Output FM: SMA Connector ...........................................5
1.2 Interfaces on the Rear Panel .........................................................................5
1.2.1 X1 – AC Supply Feed ...................................................................................5
1.2.2 ETHERNET (X6) – Control Interface (RJ-45 Remote): Connector, Female,
8-Pin .............................................................................................................5
1.2.3 X23A – Code: D-SUB Connector, 9-Pin .......................................................6
1.2.4 X23B – RF Loop: D-SUB Connector, 9-Pin Male .........................................6
1.2.5 X22A – Remote-Control Interface for Commands/Messages: D-SUB connec-
tor, 25-Pin Male ............................................................................................7
1.2.6 X22B – AMP Interface to External Amplifier: D-SUB Connector, 25-Pin
Male ..............................................................................................................8
1.2.7 X11R – AF Input Right: XLR Connector .......................................................9
1.2.8 X11L – AF Input Left (Alternative MPX): XLR Connector ...........................10
1.2.9 X21 – Input AES/EBU (Alternative MPX): XLR Connector .........................10
1.2.10 X12 – AUX1/RDS Input (BNC) ...................................................................10
1.2.11 X13 – Output Pilot: BNC .............................................................................11
1.2.12 X14 – AUX2 Input (BNC) ............................................................................11
1.2.13 X9 – 10 MHz External Reference (BNC, Reserved) ..................................11
1.2.14 X8 – Seconds Pulse from External GPS Receiver (BNC, Reserved) ........11
1.2.15 X5 – GPS Antenna (BNC, Reserved) .........................................................12
1.2.16 X2 – RF Output FM: N or 7/16 Connector ..................................................12
1.2.17 X31 – Fan E1 .............................................................................................12
1.2.18 X32 – Fan E2 .............................................................................................12