Chapter 4 Putting into Operation
5300.9677.72 - 4.5 - EN-4
4. If necessary, set the transmitter to OFF in the Transmitter > Operation menu window .
5. If necessary, set the correct frequency in the Transmitter > Exciter > RF menu window.
6. Disconnect the transmitter from the power supply and reconnect the interlock loop.
7. Reconnect the transmitter to the AC supply.
The exciter boots with the most recently set parameters.
1.3 Operating the Transmitter
Note Detailed information on operating the transmitter can be found in the "Operation" section.
To Next Page
Loading...
