Chapter 4 Putting into Operation
5300.9677.72 - 4.11 - EN-4
State Displays the status of the channel concerned
Channel 1
(Primary)
For setting the audio input and stereo mode for channel 1
a)
Possible selections:
– AF Mono L
– AF Mono R
– AF Mono (L+R)/2
– AF Stereo
– AES Mono L
– AES Mono R
– AES Mono (L+R)/2
– AES Stereo
– MPX Inp2
– MPX Inp3
State Status of channel 1 (primary audio input):
– OK
Channel 1 is operating normally.
– One Ch. Not OK
In the case of modulation with stereo or with mono L+R, this status is
displayed if only one of the two feeds for left and right is operating
normally but the other feed is subject to interference.
– Not OK
Channel 1 has failed completely.
Channel 2
(Secondary)
For setting the audio input and stereo mode for channel 2
b)
Possible selections:
– AF Mono L
– AF Mono R
– AF Mono (L+R)/2
– AF Stereo
– AES Mono L
– AES Mono R
– AES Mono (L+R)/2
– AES Stereo
– MPX Inp2
– MPX Inp3
– Not used
State Status of channel 2 (secondary audio input = standby):
– OK
Channel 2 is operating normally.
– One Ch. Not OK
In the case of modulation with stereo or with mono L+R, this status is
displayed if only one of the two channels is operating normally but the
other channel is subject to interference.
– Not OK
Channel 2 has failed completely.
– Not used
No standby input has been defined.
Entry/display Description
To Next Page
Loading...
