Rohde ST 411 - Page 90

87 / 327 - EN -
Step Activity Remark
5
Turn the fuse holder anti-clockwise so that it
releases from the lock.
Tool:
7 mm slotted screwdriver
6
Remove the fuse carrier with the fuse from the
housing.
7
Insert a new fuse.
⇒ The fuse can be inserted in both directions.
Fuse type:
5 x 20 mm / 3.15 A T micro-fuse
ROHDE item no.: 708051
8
Reinstall the fuse in reverse order.
Tool:
7 mm slotted screwdriver
9
Connect the control unit connection cable to the
kiln.
10
Switch on the kiln.
Set the main switch on the kiln to the “I/ON” position or
plug in the power plug.
11
Switch the control unit on.
12
Check the control unit is working.
If the control unit still cannot be switched on, contact a
qualified electrician, the local specialist
or the manufacturer.