Roland Jupiter-Xm - Using the Bluetooth Functionality; Bluetooth Audio Connection; Bluetooth MIDI Control

16
Reference Manual Ver. 1.5 and later
Selecting the Parts to Perform
Here’s how to select the parts that you’ll perform from the keyboard.
1. Press the [PART] button.
The [1]–[16] buttons switch to part select mode.
2. Press the [6]–[10] buttons to switch the performance parts
on/o.
Parts that are on are shown with a “K .”
When a [6]–[10] button is lit, SCENE ZONE EDIT “Keyboard Sw” setting
of the corresponding part turns “ON,” allowing you to play it from the
keyboard.
Assigning Functions to the [1]–[10] Buttons
The JUPITER-Xm lets you assign the desired functions to the [1]–[10]
buttons in part select mode.
1. Press the [MENU] button.
2. Use the [1] knob to select “SYSTEM,” and then press the
[ENTER] button.
You can also make this selection by using the PAGE [ ] [ ] buttons
instead of the [1] knob.
3. Use the [1] knob to select the “PART Btn Asgn” item, and use
the [2] knob to change the value.
You can assign the functions that occur when you press the [1]–[5]
buttons or the [6]–[10] buttons, and the functions that occur when
you hold down the [SHIFT] button and press the [1]–[5] buttons or the
[6]–[10] buttons.
Parameter
[1] knob
Value
[2] knob
Explanation
1-5,
1-5+ (S),
6-10,
6-10+ (S)
No Assign Nothing is assigned.
PartSel Select the current part.
Part+KeySw
Simultaneously turn on/o the parts that
play and turn on/o the performance
parts.
KeySw Turn on/o the performance parts.
PartSw Turn on/o the parts that play.
ArpSw Turn on/o arpeggio performance.
EfxSw Turn on/o eects.
* The “+(S)” following the parameter name means “while pressing the [SHIFT]
button.”
4. To save the changes, press the [WRITE] button.
A conrmation message appears.
If you decide to cancel, press the [EXIT] button.
5. To execute, press the [ENTER] button.