Roland Jupiter-Xm - Settings for the Entire Unit; Automatic Power Off (Auto Off); Returning to Factory Settings

22
Eects section
[MFX] knob
Adjusts the MFX depth for each part.
The MFX type can be specied by the edit page “TONE MFX” setting.
[DRIVE] knob
Species the amount of drive distortion.
MEMO
5 Be aware that the drive depth cannot be specied individually for each part.
5 To enable drive, set the SCENE PART EDIT “Output” to “DRIVE.”
[REVERB] knob
Adjusts the reverb depth for each part.
[CHORUS] knob
Adjusts the chorus depth for each part.
[DELAY] knob
Adjusts the delay depth for each part.
[DELAY TIME] knob
Adjusts the delay time.
Multi function section
When using the multi function, press the [FUNCTION] button to make it lit.
[MONO] button
([11] button)
If you turn the Mono function on by making this button light, the
sound plays monophonically (one note at a time).
[UNISON] button
([12] button)
If you turn the Unison function on by making this button light, slightly
pitch-shifted copies of the same tone as the tone are layered to make
the sound thicker.
MEMO
The eect depth diers depending on the settings of the selected tone.
[VELOCITY OFF] button
([13] button)
If you turn the Velocity O function on by making this button light,
notes play without being aected by your keyboard playing dynamics.
[PORTAMENTO] button
([14] button)
If you turn the Portamento function on by making this button light, you
can make the pitch change gradually between notes.
If you hold down the [SHIFT] button and press the [PORTAMENTO]
button, a screen appears where you can adjust the speed of pitch
change.
[SPLIT] button
([15] button)
If you turn the Split function on by making this button light, you can
perform with the keyboard divided into two regions.
If you hold down this button and play a key, the keyboard is divided
into regions at that key.
The Split function turns on/o each time you press the [SPLIT] button.
* This function can be used to divide the keyboard only when using PART1
and PART2. If you want to divide the keyboard using other parts, refer to
“Specifying the Key Range” (p. 17)
[DUAL] button
([16] button)
If you turn the Dual function on by making this button light, you can
play two sounds layered together.
If you hold down the [SHIFT] button and press the [DUAL] button, the
left side of the keyboard plays the PART1 sound and the right side of
the keyboard plays the PART2 sound.
The Dual function turns on/o each time you press the [DUAL] button.
* This function can be used to layer sounds only when using PART1 and PART2. If
you want to layer the sounds of other parts, turn “KeySw” “ON” in SCENE PART
EDIT or as described in“Selecting the Parts to Perform” (p. 16).
MEMO
The parameters that can be edited using the controllers dier
depending on the model of the sound and on the type of edit page
that is shown.
For details, refer to “Correspondence Between Controllers and
Parameters” (p. 27).
Editing a Scene
(SCENE EDIT)
Eects section
Multi function section
* You can use the knobs and buttons to instantly edit the scene even while you perform.