Roland V-1200HDR Guide

5
Introduction
Preparing V-1200HD RCS
V-1200HD RCS Operating Environment
Compatible Operating Systems
Windows Microsoft Windows 7 Service Pack 2
Mac OS X 10.9 or later
Processor
Windows
Intel Core 2 Duo or higher, or compatible processor
* The compatibility of compatible processors is not assured.
Mac Intel Processor
Memory (RAM)
2 GB or more of RAM
64 MB or more of VRAM
Required Disk Space 200 MB or more
Display Resolution/Colors
1,920 x 1,280 resolution or higher, Full Color (24-bit) or higher
On computers running Windows, the Aero interface must be enabled.
Other Matters Connecting to the V-1200HD requires a LAN connection.
* Operation of V-1200HD RCS on a standard computer that satises the conditions just described has been conrmed, but all operation under these conditions is not
assured. Please be aware that even under identical conditions, computer-specic dierences in design specications or usage environment might result in dierences
in processing capacity.
Making the Network Settings on the Computer
The network settings for the computer must be changed when using V-1200HD RCS in the online mode (p. 7).
* No network settings are needed when using V-1200HD RCS in the oine mode (p. 7).
Windows
1. Click Control Panel  “Network and Sharing Center”  “Change adapter settings.”
* When Control Panel is in Category View, click Control Panel  “View network status and tasks”  “Change adapter settings.”
2. Right-click the network connection you’re using, then click Properties.
3. Select “Internet Protocol Version 4 (TCP/IPv4)” and click Properties.
4. Select “Use the following IP address” then enter the values shown below and click “OK.”
Obtain an IP address automatically Unselected
Use the following IP address Selected
IP address
First :192.168.10.1
Second
(*1) :192.168.10.2
Subnet mask 255.255.255.0
Default gateway Blank
Obtain DNS server address automatically Unselected
Use the following DNS server addresses Selected
Preferred DNS server Blank
Alternate DNS server Blank
(* 1) By using an Ether net switching hub, you can connect up to two computers on which V-1200HD RCS
is installed and set up to the V-1200HD.
When connecting two computers, you must set a dierent IP address and ID for each
computer. Set the IP address for the second computer to “192.168.10.2.”
For information on setting the ID, refer to “Connecting Multiple Controllers to the
V-1200HD” (p. 9).

Roland V-1200HDR Specifications

General

Brand	Roland
Model	V-1200HDR
Category	Controller
Language	English